Operation Manual

serious, yet. Pending Codes will not turn on the malfunction indicator

lamp (MIL). If the fault does not occur within a certain number of warm-

up cycles, the code clears from memory.

1) Use the UP/DOWN scroll button to select Read Codes from the Diagnostic

Menu and press ENTER.

2) Use the UP/DOWN scroll button to select Stored Codes or Pending Codes

from the Fault Codes menu and press ENTER.

If there are no Diagnostic Trouble Codes present, the display indicates

"No (pending) codes are stored in the module!" Wait a few seconds or

press any key to return to the Diagnostic Menu.

3) View DTCs and their definitions on screen.

The control module number, sequence of the DTCs, total number of

codes detected and type of codes (Generic of Manufacturer specific)

will be observed on the upper right hand corner of the display.