Operation Manual

14
The control module number, sequence of the DTCs, total number of codes
detected and type of codes (Generic of Manufacturer specific) will be
observed on the upper right hand corner of the display.
If retrieved DTCs contain any manufacturer specific or enhanced codes, a
"Manufacturer specific codes are found! Press any key to select vehicle
make!" message comes up prompting you to select vehicle manufacturer
to view DTC definitions. Use the UP/DOWN scroll button to select
manufacturer and then press ENTER to confirm.
This function is performed with key on engine off . Do not start the engine.
Before performing this function, make sure to retrieve and record the
trouble codes.
After clearing, you should retrieve trouble codes once more or turn
ignition on and retrieve codes again. If there is still some trouble codes for
hard troubles, please find the reason caused the trouble code firstly, and
then solve the problem. Now, the trouble codes can be erased.
If the manufacturer for your vehicle is not listed, use the UP/DOWN scroll
button to select "Other" and press ENTER.
4) If more than one DTC is found, use the UP/DOWN scroll button, as
necessary, until all the codes have been viewed.
1) Use the UP/DOWN scroll buttons to select Erase Codes from the Diagnostic
Menu and press ENTER.
4.2 Erase Codes
Notes: