Operation Manual

12
4. OBD II Diagnostics
CAUTION: Don't connect or disconnect any test equipment with ignition
on or engine running.
Stored codes are also known as "hard codes" or "permanent codes".
These codes cause the control module to illuminate the malfunction
indicator lamp (MIL) when an emission-related fault occurs.
If the scan tool fails to communicate with the vehicle's ECU (Engine
Control Unit), a "LINKING ERROR!" message shows up on the display.
1) Turn the ignition off.
2) Locate the vehicle's 16-pin Data Link Connector (DLC).
3) Plug the scan tool cable connector into the vehicle's DLC.
4) Turn the ignition on.
5) Press ENTER to enter Main Menu. Use the UP/DOWN scroll button to select
Diagnostics from the menu.
6) Press ENTER to confirm. A sequence of messages displaying the OBD II
protocols will be observed on the display until the vehicle protocol is detected.
Verify that the ignition is ON;
Check if the scan tool's OBD II connector is securely connected to the
vehicle's DLC;
Verify that the vehicle is OBD II compliant;
Turn the ignition 'off' and wait for about 10 seconds. Turn the ignition back to
'on' and repeat the procedure from step 5.
4.1 Read Codes
Turn the ignition on
Press any key to con.
Main Menu
La n g u a ge
Con tr a st
U
ni t o f M ea s u re
OBDII D i a g n os ti c s
VOLVO D i a g n os ti c s