Specifications

Installing a CP-20A Remote
This chapter covers rack installation for the CP-20A Remote Panel (Sales Order
#900-258), as well as instructions for linking multiple panels. When the
installation is complete, a test switch should be executed (see Chapter 2).
General Specifications
General specifications* that may be useful before installation include:
Parameter Value
Cable for X
N
Net
Communications
X
N
Net Link Cable or two-conductor, 20 AWG, 7/28 strand
cable with a drain wire or shield (such as Alpha 2412C)
Distance: 1000 ft. (304.8 m) total, including linked panels
Power
9 volt @ ³ 500 mA
Humidity 0 to 90% non-condensing
Dimensions
0.93 in. (2.36 cm) depth
19.0 in. (48.26 cm) width with mounting ears
5.2 in. (13.21 cm) height, 3 RU
Weight Approximately 2 lb. (0.91 kg) per panel
* Features and specifications described in this publication are subject to change
without notice. Full specifications for all AutoPatch products are located on the
AutoPatch website (www.autopatch.com).
Rear View
Caution: The Service connector is not to be used as a point of control. It
should only be used for service as directed by AutoAssist (technical support).
CP-20A Control Panel Operation 10-1
Installing Remote
Figure 3: Rear view of CP-20A Remote Panel
Power Connector
Service Connector
Comm Link Connectors
Serial Number