Setup guide

I
Input and Output Connectors
Attachment points on the rear of a Modula enclosure for devices that
connect to the system. Input and output signal cables attach to the input
and output connectors. Standard Modula audio and data connectors are
3 position terminal block; video and sync connectors are BNC.
Input Board
A circuit board that receives video, audio, or data signals from outside
sources.
L
LCD (Liquid Crystal Display)
The screen on the front of the Modula for user interaction.
Level
A set of input and output signals that are grouped and, therefore, switch
together. In a configuration file, a level is referred to as a “virtual
matrix.”
Local Preset
A pre-defined set of signal routings that can be executed at any time.
Presets are defined in the configuration file.
M
Matrix Switcher
The hardware and software necessary to switch signals. Matrix switchers
are also known as routing switchers or routing matrices.
O
Output Board
A circuit board that routes input signals to specified destinations.
Output Connectors
(see Input and Output Connectors)
R
Power Supply
Contains a power switch, a power connector, and a fuse. The power
supply is on rear of the enclosure to the far left.
Installation and Setup Guide