Setup guide

6. Once you have added the sync board(s), verify the system’s response
by reapplying power to all enclosures containing video in the system
and checking the splash screen.
7. Update the configuration file using X
N
Connect to enable the sync
board.
To update the configuration file using X
N
Connect:
1. Open your configuration file in X
N
Connect (see page 9-4).
2. In the Virtual Matrix view, right click the virtual matrix, and choose
Assign Signals from the shortcut menu.
The Assign Virtual Matrix Signals dialog box appears.
3. Click the Vertical Interval Timing check box to enable the sync
board.
4. Click OK.
5. Connect the enclosure to your PC via the serial ports.*
6. From the Network menu, select Download Configuration.
All parts of the virtual matrix will now switch on a vertical interval.
*If your PC does not use Com 1, open the Edit menu and select
Modify PC Serial Port Settings to change the serial port information.
Installation and Setup Guide 10-7
Adding Boards
Hardware
Output slots:AO:AO:AO:AO:AO:AO:AO:AO
Sync board detected: checking for sync signal...ok. Sync switching enabled.
Interface 1: BCS mode RS232 port, 9600 (8/1/N)
Interface 2: BCS mode RS232 port, 9600 (8/1/N)
Vertical Interval Timing