Setup guide

3. Line up the board with the board guides that are on the top and
bottom of the board slot. The board has the correct end up when the
back of the connectors are to the right of the board. Carefully push
the board into the enclosure until it snaps into place.
4. Insert the screws into the holes on the connector assembly and
tighten the screws until they are snug.
5. Fasten the house sync or blackburst cable to the sync board.
10-6 Installation and Setup Guide
Adding Hardware
Hardware
Insert the screws and tighten until snug
Carefully push the board into the enclosure
Fasten house sync or blackburst cable to sync board