Setup guide

10.1 Adding Boards
Input and Output Boards
The number of input and output signals in an enclosure determines the
number of input and output boards. In an enclosure, signals are sent and
received through input or output connectors. Each input and output board
has four connectors.
Warning: To avoid ESD (Electrostatic Discharge) damage to sensitive
components, make sure you are properly grounded (see the Caution page
inside front cover) before handling any internal Modula materials.
To add an input or output board:
1. Turn off the enclosure.
2. Remove the plate that covers the empty board expansion slot.
Make sure you are working with the correct slot. If you put the board
in the wrong slot, signal routing is affected. The board’s location
must match the system’s configuration information (downloaded
from the configuration file). A new configuration file is sent with
new boards.
10-2 Installation and Setup Guide
Adding Hardware
Remove the plate that covers the empty board slot
Hardware