Setup guide

5. Follow the directions in the subsequent dialogs in the install
program.
6. Review the Readme.txt file found on either Disk 1 or after
installation in the default install location C:\AutoPtch\Connect\.
To launch X
N
Connect:
1. From the Start menu, select Programs.
2. Select AutoPatch Applications (or any other file group you selected
during the install).
3. Select the Connect file group.
4. Select the Connect program.
The X
N
Connect program opens.
9.3 Panes, Views, and Dialog Boxes
X
N
Connect displays two panes. The graphics are located in the left pane
and the properties of the currently selected graphic are in the right pane.
At the top of the left pane, you can access the different graphical
representation views from three tabs: Hardware, Virtual Matrices, and
Signal Devices. Hardware, such as enclosures and control panels, appear
in the Hardware view; existing virtual matrices appear in the Virtual
Matrices view; and signal devices, such as VCRs or projectors, can be
added to the Signal Devices view. As you switch from view to view, the
properties displayed in the right pane automatically change to correspond
to the new graphics.
Installation and Setup Guide 9-3
Panes, Views, and Dialog Boxes
Configuration Files