Setup guide

8.3 Checking Volume Status
You can only check Volume status from an external controller via BCS
commands.
To check the Volume status for a specific destination, enter the
command using the specified command line format below (where “#”
represents any valid audio level or destination number). The decibel
amount in the result of the status check is specified as a decimal number
to the tenth place without the decimal marker; for example if the result is
–480, the decibel level is –48.0 or if the result is 65, the decibel level is
6.5.
Volume Command:
SL#O#VT
To cancel an incomplete BCS command, enter the “X” command at
any time.
Volume Examples:
BCS Command Action Result
SL0O3VT
Checks Volume status for Level 0,
destination 3
SL0O3VAT( 35 ) [3.5 dB]
SL0O8VT
Checks Volume status for Level 0,
destination 8
SL0O8VAT( 5 ) [.5 dB]
SL0O2VT
Checks Volume status for Level 0,
destination 2
SL0O2VAT( -125 ) [-12.5 dB]
SL0O7VX Cancels the incomplete command
Note: You cannot enter multiple levels or destinations in
Volume Status commands.
Installation and Setup Guide 8-7
Using BCS Commands
Volume Control