Setup guide

The switch to Destination 1: Main Projector Rm A occurs as soon
as the Control Dial is pressed (when the line is dark, the switch is
active).
4. Choose the Source command to return to the Select Source to
Change screen to make additional test switches or choose the
Main Menu command to return to the Main Menu screen.
If the switch did not execute properly:
q
Check all power switches to make sure the source and destination
devices are turned on.
q
Check all link and signal connections on the rear of the enclosure(s)
to make sure everything is physically set up correctly.
q
Attempt the switch again.
If the switch still does not work, call AutoAssist (see Technical Support,
page vi).
7-4 Installation and Setup Guide
Executing a Test Switch
Test Switch