Setup guide

Executing a Test Switch

Execute a test switch to verify the system is working properly before

attaching all inputs and outputs. Aside from having signal cables

attached, the system is ready to perform switches when it ships from the

factory.

You can execute a test switch from the following:

Local control panel (CP-20MD or CP-10MD)

An external serial controller (computer, AMX, Crestron, etc.)

via BCS (Basic Control Structure) commands

Note: Before executing a test switch, attach only the first two inputs and

outputs described in the AutoPatch “Modula Connector and Groupings

Guide” that came with your system.

The local control panel test switch examples (CP-20MD on page 7-2 and

CP-10MD on page 7-5) route input 2 to output 1 on Level 0 (your system

may have been programmed with a different level). The BCS command

test switch (see page 7-7) routes input 1 to output 2 on Level 0. Before

executing these switches, make sure the first two inputs and outputs are

connected exactly as shown on the AutoPatch “Modula Connector and

Groupings Guide.”

Installation and Setup Guide 7-1

Test Switch