Setup guide

6.4 Startup from
a Serial Control Device
After applying power and turning on the enclosure(s), the splash screen
displays startup diagnostic information, followed by “Ready.” If you
need details regarding items on the screen or if errors are reported, call
AutoAssist (see Technical Support, page vi). A sample splash screen for
a 48x16 Modula is shown below. The system is ready for a test switch
(see Chapter 7, “Executing a Test Switch”).
Installation and Setup Guide 6-3
Startup from a Serial Control Device
Power & Startup
AutoPatch Modula signal router booting on Fri Jan 01 00:00:00 2001
Host software version 2.1.6
Appcode version 1.2.2 D
Hardware driver version 0.1.5 D
Built on May 07 2001 15:17:57
System PLD version A6
System startups: 20, cumulative service hours: 257.0, total switches: 1581.
XNet address: 0x04ab.
NVRAM settings: warm reboot. User preferences reset to last valid state.
Assuming 48x16 I/O configuration.
48x16 Video UWB switch board detected at 0x80800000
IO slots:VI:VI:VI:VI:VI:VI:VI:VI:VI:VI:VI:VI:VO:VO:VO:VO
Interface 1: BCS mode RS232 port, 9600 (8/1/N)
Interface 2: BCS mode RS232 port, 9600 (8/1/N)
Interface 3: 10Base2 BNC Ethernet
Interface 4: Neuron bridge version 1.0.2
Virtual matrix status: valid.
Virtual matrix count: 1
---------------------------------------
'default'(0), 48x16x1,
---------------------------------------
Ready
Startup information in HyperTerminal