Setup guide

6.1 Applying Power
To apply power:
1. Plug each enclosure into a power source.
WE RECOMMEND SURGE PROTECTORS AND/OR AN AC
LINE CONDITIONER.
2. Press the “1” side of the power switch to turn it on.
6.2 Startup from the
CP-20MD Control Panel
After applying power and turning on the enclosure(s), the CP-20MD
Control Panel displays the Main Menu screen. The system is ready for a
test switch (see Chapter 7, “Executing a Test Switch”).
6.3 Startup from the
CP-10MD Control Panel
After applying power and turning on the enclosure(s), the CP-10MD
Control Panel displays the Command screen. The system is ready for a
test switch (see Chapter 7, “Executing a Test Switch”).
6-2 Installation and Setup Guide
Applying Power and the Startup Sequence
Power & Startup
www.autopatch.com
Change
Adjust
Audio
Status
Macro
System
Setup