Setup guide

Typical connectors on a Modula enclosure could include:
Signal Type Connector Type
Analog audio
(balanced or unbalanced)
Pluggable 3 position terminal block
Digital audio BNC
Analog video BNC
Digital video BNC
Sync BNC
When attaching input and output signal cables, refer to the sheet labeled
“AutoPatch Modula Connector and Groupings Guide” that was included
in the shipping box(es). The sheet shows you where to attach each signal
cable on the rear of each enclosure. Follow the sheet exactly; the system
was programmed at the factory to operate only as indicated on the sheet.
Note: Before connecting all signal cables, attach only the first two
inputs and outputs from the “AutoPatch Modula Connector and
Groupings Guide,” and then perform a test switch to verify that the
system is working properly. See Chapter 7 for details on performing a
test switch.
To attach video inputs and outputs, fasten the video cable onto the
input or output connector (see graphic below).
Make sure video signals are attached to video connectors and sync
signals are attached to sync connectors. The connectors look identical,
but the “Cabling Guide” identifies them.
4-2 Installation and Setup Guide
Attaching Inputs and Outputs
Attach a video cable to a BNC
connector
Inputs & Outputs