Setup guide

To link more than two enclosures via X
N
Net Communication link
connectors:
1. Insert the wires from the first X
N
Net link cable into the terminal
block on the first enclosure in the system (as shown in the graphic on
the bottom of page 3-3).
2. Insert the wires from the other end of the first X
N
Net link cable along
with the wires from the second X
N
Net link cable into the same
terminal block in the next enclosure in the system, as shown in the
graphic below, repeating as necessary for additional enclosures.
Installation and Setup Guide 3-5
Link more than two enclosures via the X Net Communication link port
Linking