Setup guide

Output Connectors
1.2 Rear of the Enclosure
The rear of the enclosure has the input and output connectors, three
expansion/control slots (with CPU board in one), power supply, and
serial number (see graphic above).
The following segments briefly introduce the hardware on the rear of the
enclosure.
Input and Output Connectors
Input and output connectors are the attachment points for devices that
connect to the system. The number and type of connectors depend on the
number and type of input and output boards. Input and output connectors
are numbered separately. The four connector numbers for each board are
above and to the right of its top connector. This pattern continues on each
board (see graphic above). Looking at the rear of the enclosure, the
inputs (sources) are on the left side, and the outputs (destinations) are on
their right. A single enclosure can handle a combination of signals, such
as analog audio, analog video, digital video, and sync.
1-6 Installation and Setup Guide
Unpacking the Modula
Unpacking
Numbering starts with the top channel of the left-most board
Rear view of a Modula enclosure
Expansion/Control Slots
Power Supply
Serial Number
CPU Board in Expansion/Control Slot
Input Connectors