Setup guide

Chapter 7 — Executing a Test Switch
Executing a Test Switch Using the CP-20MD Control Panel.......7-2
Executing a Test Switch Using the CP-10MD Control Panel.......7-5
Executing a Test Switch Using BCS Commands .................7-7
Chapter 8 — Adjusting and Checking Volume
Adjusting Volume Using the CP-20MD Control Panel ............8-2
Adjusting Volume Using BCS Commands .......................8-4
Adjusting Volume–Absolute Method .......................8-4
Adjusting Volume–Relative Method ........................8-5
Adjusting Volume–Increment/Decrement Method ..........8-6
Checking Volume Status ......................................8-7
Chapter 9 — Managing Configuration Files
Conceptual Overview .........................................9-1
Installing and Launching ......................................9-2
Panes, Views, and Dialog Boxes................................9-3
Opening and Downloading a Configuration File...................9-4
CP-20MD Control Panel ..................................9-5
Modifying a Configuration File..................................9-7
Configuring Local Presets.................................9-7
Modifying Groupings ....................................9-10
Chapter 10 — Adding Hardware
Adding Boards .............................................10-2
Input and Output Boards ................................10-2
Vertical Interval Sync Board/Expansion Board .............10-5
Adding Enclosures ..........................................10-8
Appendix A — AutoPatch Service and Returns Policy
Service......................................................A-1
Return Authorizations ....................................A-1
Claims for Shipping Damages .............................A-1
Replacement Policies and Procedures .........................A-2
Special Notice ...............................................A-3
Installation and Setup Guide