Operating instructions

Programming
29
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
L Before registering the repeater to this base
unit, you must turn the repeater mode on.
L Do not use more than one repeater at a
time.
Setting the repeater mode
1 8(138
2 {r}: Select the desired setting. s M
s {ic}
Note:
L After turning the repeater mode on or off, _
is displayed on the handset momentarily.
This is normal and the handset can be used
once w is displayed.
Registering the DECT repeater (KX-
A405) to the base unit
Note:
L Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1 Base unit:
Proceed with the operation for your
model.
■ KX-TG6611/KX-TG6612
Press and hold {x} for about 5
seconds. (No registration tone)
■ KX-TG6621/KX-TG6622
Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L The next step must be completed
within 90 seconds.
2 DECT repeater:
Connect the AC adaptor, then wait until
the & indicator lights green.
3 Base unit:
To exit the registration mode, press {x}.
L The registration tone stops.
(KX-TG6621/KX-TG6622)
TG6611_6621NZ(e).book Page 29 Monday, February 14, 2011 8:43 AM