Installation manual
C3 RS915 REV. A
30
TROUBLE SHOOTING
There are 5 reasons why the remote start button will not respond from the
transmitter.
1. The Black/White Neutral Safety wire is not grounded. Must be grounded to start.
2. Hood Pin switch White/Black wire has a ground present. Must not show ground to
start.
3. Brake pedal switch White/Violet has 12 volt present. Must not show 12 volt to start.
4. The system is in Valet mode.
5. The remote start feature programming has not been programmed to start the
vehicle. The remote start must be programmed how to start the vehicle.
SHUTDOWN DIAGNOSTICS
The unit has the ability to report the cause of the last shutdown of the remote start
system.
Enter:
1. Turn the Ignition switch to ‘ON position.
2. Press the button on the transmitter.
3. The LED will now report the last system shutdown by flashing for one minute in the
following grouped patterns:
LED
Flashes
Shutdown Mode
1 (-) Safety Shutdown input (Hood)
1. Close the hood.
2. Check H6/14 White/ Black wire connection.
2
(+) Safety Shutdown input (Brake)
or
Neutral Safety Switch input fail.
1. Check H6/18 White/ Violet wire connection.
2. Move the Enable Toggle Switch to “ON”
position. (If installed.)
3. Move the gear selector to “Park”/
“NEUTRAL” position.
4. Check H6/8 Black/White wire connecti on.
3
No RPM or
Low Voltage.
Tachometer Checking Type:
Check H6/10 White/Red wire connection
Voltage Checking Type:
Program the “CHECK LEVEL” from
“Hi Check Level” to “Low Check Level”
4 Wait-to-Start time out
Please check H6/13 White/ Green wire
connection
5 Over-rev
6 System timed out
7 Transmitter
8
Tach. Signal has not been
learned
Re-learning the RPM (Start Feature E – 2 /
3)
TESTING YOUR INSTALLATION:
Caution!! The follow procedure must be performed after the installation of the Remote
Start Device. It is the responsibility of the installing technician to complete these tests.