Programming Manual

Press Up or Down Button symbol

Searching For Microstimulator antenna symbol

Recharge Remote symbol

Low Battery symbol

Depleted Battery symbol

Battery Charging symbol

Fully Charged Battery symbol

Alert Indicator symbol

Symbols and definitions used only for the Pulsante® Surgical Tools:

Single Use Only

Sterilized using Ethylene Oxide

Symbols and definitions used for the Pulsante® Programmer Software on Clinician Programmer:

Tilt Symbol indicates that the

selected stimulation amplitude is not

being delivered

Power ON/OFF button symbol

4. PATIENT IMPLANT IDENTIFICATION CARD

A Patient Implant Identification Card is packaged with the Microstimulator. Advise the patient to carry

the identification card at all times. The identification card must be filled out with pertinent patient

information prior to the patient being discharged from the implanting center.

5. PULSANTE® SPG MICROSTIMULATOR SYSTEM OVERVIEW

The rechargeable Pulsante® SPG Microstimulator System (the “System”) electrically stimulates the

sphenopalatine ganglion (SPG) peripheral nerve structure (Figure 1). The rechargeable System

includes a miniaturized Microstimulator, which is placed at the SPG through an incision in the

patient’s gum. The Microstimulator has six electrodes, which are programmed by a trained clinician

using the Programmer Software to customize therapy to the patients’ individual needs. The

Microstimulator is then controlled and powered by a Remote Controller. The patient can use the

Remote Controller to treat their headaches as needed. Periodically, the Remote Controller battery

needs recharging using the Remote Controller Charger provided.