User's Manual
Table Of Contents
- 186_1100_001_04
- 1. PURPOSE
- The purpose of this document is to provide specifications for the CarFi User’s guide for the Stewart Autonet branded router.
- 2. SCOPE
- This document applies to the fabrication and assembly of the Stewart CarFi User’s guide.
- 3. RESPONSIBILITIES
- It is the responsibility of contract manufacturer/packaging supplier to follow this document, or create an approved internal document.
- 4. DEFINITIONS
- 5. APPLICABLE DOCUMENTS
- 6. DIMENSIONS
- 7. MATERIALS/PROCESS
- 8. TESTING
- 9. REVISION SYNOPSIS
- 10. Approvals
- 186_1100_001_04_pg_22
- 186_1100_001_04
Regulatory Information
(To maintain compliance with FCC exposure
guidelines, use only accessories supplied or approved by Autonet Mobile Inc.)
Exposure to Radio Frequency Signals
Autonet Mobile is a low power radio transmitter and receiver. When it is turned on, it sends
out and receives RF signals. Autonet Mobile complies with FCC guidelines respecting safe
levels of RF exposure for handled wireless devices, which in turn are consistent with the
following safety standards previ
ously set by certain standards bodies:
ANSI/IEEE C95.1-1999, IEEE Standard for Safety Levels with Respect to Human Exposure
to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz -- National Counsel on
Radiation Protection and Measurements (NCRP) Report 86, - 1986, Biological Effects and
Exposure criterion for Radio Frequency Electromagnetic Fields -- International Commission
on Non-Ionising Radiation Protection (ICNIRP) 1988, Guidelines for limiting exposure to ti
me-
varying electric, magnetic, and electromagnetic fields (up to 300 GHz)
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in acc
ordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
This equipment complies with the FCC RF radiation exposure
limits set forth for an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your body.
Specific Absorption Rate Data
Autonet Mobile meets U.S. government requirements for exposure to radio waves. Autonet
Mobile is a radio transmitter and receiver. It is designed and manufactured not to exceed the
emission limits for exposure to RF energy set by the FCC. These limits are part of
comprehensive guidelines and establish permitted levels of exposure to RF energy for the
general population. These guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation of scientific
studies. The standards
include a substantial safety margin designed to assure the safety of
all persons, regardless of age and health
. Any changes or modifications not expressly
approved by the party responsible for compliance could void the user’s authority to operate
the equipment. The FCC requires that you be notified that any changes or modifications
made to this device that are not expressly approved by Autonet Mobile may void your
authority to operate the equipment.
22