User's Manual
Table Of Contents
- 186_1100_001_04
- 1. PURPOSE
- The purpose of this document is to provide specifications for the CarFi User’s guide for the Stewart Autonet branded router.
- 2. SCOPE
- This document applies to the fabrication and assembly of the Stewart CarFi User’s guide.
- 3. RESPONSIBILITIES
- It is the responsibility of contract manufacturer/packaging supplier to follow this document, or create an approved internal document.
- 4. DEFINITIONS
- 5. APPLICABLE DOCUMENTS
- 6. DIMENSIONS
- 7. MATERIALS/PROCESS
- 8. TESTING
- 9. REVISION SYNOPSIS
- 10. Approvals
- 186_1100_001_04_pg_22
- 186_1100_001_04
Installation Instructions (continued)
Connect the 12V positive power wire for CarFi, directly from the ignition
power source. Installing the wiring in the inline harness may cause blown
fuses, etc. Installing it directly to the car battery can deplete the battery and
possibly cause a “dead” battery scenario.
When installing the wiring, do not run along any sharp chassis edges or
through any exposed sharp chassis openings. Use insulation grommets or
other appropriate insulation materials.
Mounting Locations-Do’s and Don’ts
CarFi is typically mounted in the following locations:
On the inside rear side panel in an SUV or Van.
Under the rear deck lid in a sedan.
In the trunk of the vehicle.
In a location that gives the antennas the fewest obstructions to the outside
of the vehicle.
CarFi should not be mounted in the following locations:
In a location that interferes with driving.
In a location that may have water intrusion.
In a location that has extreme dust intrusion
In a location that is extremely hot or has hot air flowing on the unit.
In a location that gets direct sunlight.
In a location within 20 cm of any passenger.
In a location under or surrounded by carpet.
In a location that does not allow heat to easily dissipate (glove box, etc.).
In a location near the dashboard, rear tray or air bag safety parts.
19