User's Manual
Table Of Contents
- 186_1100_001_04
- 1. PURPOSE
- The purpose of this document is to provide specifications for the CarFi User’s guide for the Stewart Autonet branded router.
- 2. SCOPE
- This document applies to the fabrication and assembly of the Stewart CarFi User’s guide.
- 3. RESPONSIBILITIES
- It is the responsibility of contract manufacturer/packaging supplier to follow this document, or create an approved internal document.
- 4. DEFINITIONS
- 5. APPLICABLE DOCUMENTS
- 6. DIMENSIONS
- 7. MATERIALS/PROCESS
- 8. TESTING
- 9. REVISION SYNOPSIS
- 10. Approvals
- 186_1100_001_04_pg_22
- 186_1100_001_04
Troubleshooting Guide
For a more complete listing of errors/information please visit our website or call our
customer support center: 1-800-977-2107 (http://www.autonetmobile.com/)
Problem/Error
Solution
CarFi has no power (The LED indicator
is not visible)
Please note at CarFi startup the LED
will be off for approximately 15 seconds
in its sequencing mode
(see LED sequencing pg. 16 )
Check to ensure the main enclosure is
firmly attached to the bottom docking
station.
Check to make sure the power
installation cable is properly installed,
and you have a regulated 12V DC
supply with a min. 1.8A.
Check the inline fuse. If “open” or
damage, please call our customer
support center to order a replacement.
Reboot CarFi by turning your car ignition
off and on again (while parked in a safe
location).
Connectivity issues-limited, low signal
or no signal
(If the Blue LED continues it’s fast
blinking sequence and will not go to a
solid state, you are likely in an area with
no coverage. Please call our customer
support center to review your coverage
area.)
Disconnect from the “Autonet” wireless
network and reconnect.
Ensure the cell antenna on CarFi is
secured properly.
Position CarFi in a different location in
your vehicle.
Reboot CarFi by turning your car ignition
off and on again (while parked in a safe
location).
13