User Manual
Q1® Anti-Static Gun User Manual
The Q1® Anti-Static Gun is provided with a 4-level char-
ging battery indicator placed in the upper part that will
be visible during charging and also while using the gun
when pulling the trigger.
The gun needs 3-hours charge for a full charge. This
provides an estimated autonomy of 4 hours of conti-
nuous work. There is no battery charge loss while the
tool is in stand by mode or while it is not being used,
even after a few days.
adaptor provided with a 1m wire with the appropriate
section to charge the gun and a complementary Jack
power plug to the gun socket.
damage, please contact with the manufacturer.
Clean the outer part of the Q1® Anti-Static Gun with a
damp cloth (do not use, by any means, a wet cloth), and
possible.
• The equipment is properly protected for the uses
described in this user manual.
-
rent from the one provided by the manufacturer.
• Do not short-circuit the electrodes for an extended
internal damages which can be irreparable.
• Avoid contact with the electrodes.
• Do not immerse any part of the Q1® Anti-Static Gun in
• Ensure adequate ventilation for the work area. Do not
use it simultaneously during the painting process.
responsible for the utilization of the tool and for the
compliance of the safety requirements, not only indivi-
dual’s but also the ones in the workplace. Use hearing
and eye protection.
• During the use of the gun, avoid to place the nozzle
close or directing to the eyes or ears.
• This product may interfere with the operation of
pacemakers due to high voltage discharges and other
should be informed about the possible risks before
using or being near this tool.
• Always use the charger in a safe area and regularly
control the electric wire to avoid any possible acciden-
ts caused by damage.
• This machine can only be repaired and handled by
• This machine uses compressed air, so dry, clean and
-
te purposes. It can only be used with no air in a short
distance or in small areas.
• When plugging and unplugging the tool, act in accor-
dance to the usual safety regulations.
Charge Lit LEDs
All
3
2
1 (red, steady)
has to be charged
EN