User Manual

IC STATEMENT
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS)
d'Innovation, Sciences
et Développement économique Canada. Le fonctionnement est soumis aux deux conditions
suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer
un fonctionnement
indésirable de l'appareil.
IC Radiation Exposure Statement
This modular complies with IC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter
must not be co-located or operating in conjunction with any other antenna or transmitter.
If the IC number is not visible when the module is installed inside another device, then the
outside of the device into
which the module is installed must also display a label referring to the enclosed module. This
exterior label can
use wording such as the following: “Contains IC: 11418A-BLENRF1”
when the module is installed inside another device, the user manual of this device must contain
below warning
statements;
1. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
2. Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS)
d'Innovation,
Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux
conditions suivantes :
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer
un fonctionnement
indésirable de l'appareil.