User Manual

compliance.
The module grantee shall provide a notice that
any deviation(s) from the defined parameters of
the antenna trace, as described by the
instructions, require that the host product
manufacturer must notify the module grantee
that they wish to change the antenna trace
design. In this case, a Class II permissive change
application is required to be filed by the
grantee, or the host manufacturer can take
responsibility through the change in FCC ID
(new application) procedure followed by a Class
II permissive change application.
2.6 RF exposure considerations
It is essential for module grantees to clearly
and explicitly state the RF exposure conditions
that permit a host product manufacturer to use
the module. Two types of instructions are
required for RF exposure information: (1) to the
host product manufacturer, to define the
application conditions (mobile, portable – xx
cm from a person’s body); and (2) additional
text needed for the host product manufacturer
to provide to end users in their end-product
manuals. If RF exposure statements and use
conditions are not provided, then the host
product manufacturer is required to take
responsibility of the module through a change
in FCC ID (new application).
YES
This modular complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment. This transmitter must not be
co-located or operating in conjunction with
any other antenna or transmitter.
2.7 Antennas
A list of antennas included in the application for
certification must be provided in the instructions.
For modular transmitters approved as limited
modules, all applicable professional installer
instructions must be included as
part of the information to the host product
manufacturer. The antenna list shall also identify
the antenna types (monopole, PIFA, dipole, etc.
(note that for example an “omni-directional
antenna” is not considered to be a specific
“antenna type”)).
For situations where the host product
manufacturer is responsible for an external
connector, for example with an RF pin and
antenna trace design, the integration
instructions shall inform the installer that
YES
PCB antenna with antenna gain -0.5dB