User manual

Software Operation
16
Section 3
ZonePRO
™
ZonePRO
™
User Manual
3.3.6 Front Panel Configuration
The Front Panel Setup Page allows selection of which controls will be available to the end-user
of the ZonePRO unit. If Zone Controllers are being used for page steering, source, or volume
c o n t rol of an output zone these parameters will not be available from the front panel.
Once all the Wizard pages have been completed the configuration is ready to be loaded, this
is accomplished by selecting finish. You will now be returned to the normal editing mode of
the ZonePRO GUI.
All parameters can be edited by double clicking on the module. All the individual parame-
ters are discussed, and can be seen in Section 4.
3.4 - Parameter Editing