User manual

Software Operation

Section 3

ZonePRO

™

ZonePRO

™

User Manual

Edit - Source Selection - A ZC-3, ZC-4, ZC-8, or ZC-9 can be used to provide

source selection. Select the desired ZC type and make sure it has the correct

ID number. For a ZC-3, ZC-8, or ZC-9 for each switch position, select the cor-

responding source. For a ZC-4, select the switch position 0-15 and choose the

corresponding input source (see ZC-4 switch positions within the Appendix).

Edit - Page Routing - For a ZC-3, only four zones or groups of zones can be

switched between. A ZC-4 can switch between 16 zones or groups of zones.

Like a ZC-3, the ZC-7 only has four positions, so it will only support up to four

zones or groups of zones, but it does have momentary switches that can be

used in a push-to-call fashion, where each switch must be pushed and held to

route the page to that zone or group of zones. Once you have performed all

your zone controller configurations, click NEXT to move to the Routing

Configuration.

3.3.4 Source Association

The Source Association page allows selection of the main Source, the Priority override source,

the Page source, and the output level for each of the output zones. The Source ZC page

appears as follows:

3.3.5 Routing and Zone ZC Association

The Routing configuration Page allows selection of the main Source, the Priority override

source, the Page source, and the output level for each of the output zones. If Zone

Controllers are used for either source selection or level control, these should be selected in

the Source or Level pulldown menu. If zone controllers are being used for Page Steering

select None in the Page menu for those outputs unless a microphone is always paging to that

zone in addition to the page steering.