User manual

2.4.4 Wizard Menu
The Wizard Menu provides setup functions for the unit configuration, scene changes that might
involve routing or ZC assignment changes, and automated scene changes via the real time clock
schedule. Configuration of the ZonePRO device is done from the Configuration Wizard and
allows setup of the inputs and outputs along with selection of their processing modules, zone
controller setup, signal routing, and front panel setup. For a detailed operation description see
"The Wizard" section 3.3. The image on the following page shows the first page of the
Configuration Wizard page.
The Scene Wizard allows routing and ZC assignment changes for different scenes. Scheduling
Scene Changes is done using the Schedule Wizard. Selecting the Schedule Wizard from the
Wizard Menu reveals the image below where scenes can be recalled at various times through-
out the day or week.
2.4.5 Help Menu
The Help Menu provides for some special functions like retrieving Hardware Info such as
Checksum and Fire Safety status. There is a Locate function similar to the Locate function
found under the Device Menu in the Venue view. A special provision for the 641 and 1261 is
found in the Help menu under 641/1261 Operations that can be used to do hard or soft resets
on those units if the need arises. Finally the GUI software version is found under About in the
Help menu.
2.4.6 Meters Button
The Meters Button, found at the bottom of the Unit view can be used to turn the meters off.
Turning the meters off will help speed the communication and processing of slower computer
systems. The ZonePRO Designer GUI defaults with the meters turned on.
Software Overview
Section 2
ZonePRO
™
9
ZonePRO
™
User Manual