User Manual

AN2300AT MANUAL

1. Antenna Model : AN2300AT

2. Technology: FM 2-WAY

3. Max Range : 3000 feet

4. LED : status indication

5. Button: setup key

6 Connect to iDataStart (To plug Weblink or RF-Decoder/Antenna)

pin1- Rx (Data from antenna, 0-5 Volts)

pin2- Tx (Data from iDataStart, 0-5 Volts)

pin3- GND (Ground from iDataStart)

pin4- 12V (Power from iDataStart, 12V )

The Control Center,typically located on the upper part of the front windshield.It consists of:

The In-vehicle system antenna.

The Status LED,as a visual indicator of the system’s status.

The Control button,for placing the system into Valet Mode and to perform the Emergency

Override operation.

This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled

environment.

PAGE 1
AN2300AT MANUAL 1. Antenna Model : AN2300AT 2. Technology: FM 2-WAY 3. Max Range : 3000 feet 4. LED : status indication 5. Button: setup key 6 Connect to iDataStart (To plug Weblink or RF-Decoder/Antenna) pin1- Rx (Data from antenna, 0-5 Volts) pin2- Tx (Data from iDataStart, 0-5 Volts) pin3- GND (Ground from iDataStart) pin4- 12V (Power from iDataStart, 12V ) The Control Center,typically located on the upper part of the front windshield.It consists of: The In-vehicle system antenna.
PAGE 2
IC Statement This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada .