User Guide

battery needs to be charged after about
500 mi / 800 km. To further enhance
battery time, use the optional 8–30V
wiring harness to hardwire the tracker
to external power.
Since the device runs a Low-Power ARM
Cortex-M4 it doesn’t have to power up
the GPS and GSM modules if they aren’t
used. This allows for ecient power
management and longer battery time.
Durability IP67
Automile Tracker Pro is IP67 classed,
meaning it is dust and water proof. The
device can be dropped into a body of
water up to 3.3 ft / 1 m deep for 30 min.
Encryption and security
All communication between Automile’s
cloud service and the device is XTEA
encrypted (eXtended Tiny Encryption
Algorithm). The apps communicate with
the cloud service through the use of
military graded AES-256.
Sensors
Connect up to 10 external 1-Wire sensors
such as the Automile Temperature and
Humidity Sensor. Screw one end of the
sensor cable to the tracker and the
other end to the sensor, which will then
be auto-detected in a few minutes.
Each sensor has two female connectors
so that you can chain them. They draw
power from the device so there is no
need for separate batteries.
Set up custom alerts and thresholds,
and get access to specific reports with
all sensor readings.
Sensor cables come in three lengths:
10 ft, 32 ft, 64 ft (3 m, 10 m, 20 m).
7
P
W
R
SEN