User's Manual

Telephonic Car Alarm & Remote Starter
User’s Manual
New Generation Technology - The Telephonic Car Alarm & Remote Starter - www.ngtwindsor.com
4
8.0 TWO LEVEL TELEPHONE NOTIFICATION
When the alarm is activated by the vibration sensor the phone rings: 2-6 times, depending on service provider. There is
no need to acknowledge the call since it will cease automatically. There will not be any more calls until the alarm is
activated again. Should – however – the door be pried open, the numbers of rings on the telephone is 6 to10, followed by
a short pause, then ringing, and pause again. This repeats maximum 13 times (a counter will automatically
“acknowledge” it), unless the call had been acknowledged by answering the phone and pressing button # 1, or # 2, or #
3, and ending the call (END).
Once the call has been acknowledged, the alarm will be reset to ON mode in case of repeated intrusion.
In case of such an alarm the car should be checked.
The outgoing call from the alarm (the number of rings on the user’s phone) can be adjusted at the GRA 02 central
processing unit, in case of refined adjustment (up to 13 rings) with VP3, in case of unrefined adjustment (13 or more
rings) with JUMPER JP2. This can only be done by an expert at the time of installation.
7.0 USING THE THIRD BUTTON FOR MULTI USERS
The GRA 02 alarm center can handle 3 telephone numbers. If more people use the car, it is advisable to attach the
telephone number/voice sample to the first two buttons (ON 1 and ON 2) and to leave the third button (ON 3) blank. Thus
the users – if there are more than two – can use ON 3 for the alarm, which will not utilize the phone notification feature.
(ex. company car)
8.0 TURNING ON THE ENGINE VIA TELEPHONE
If your car has an automatic transmission and its technical characteristics permit it, you can start up the engine with
module RS 02 REMOTE STARTER, from any distance, as well as its heating, cooling system. Turning on the engine via
telephone is completely synchronized with the alarm; the alarm will still be monitoring the doors. In case of a forced
entry the alarm will immediately sound, the telephone notification will take effect, and the engine will come to a stop.
Also, if you forget about the car the system will automatically shut down in 5 minutes.
9.0 REMOTE CONTROL BY TELEPHONE
We can transmit 9 instructions on the telephone and send programs to GRA 02 car alarm central processing unit, by
DTMF code. Since the alarm’s inner timings are as one complex unit, it is advisable to start trying the telephone-
programming 2-5 minutes after we turned the alarm on.
9.1 Instruction-programming:
1. Call the alarm’s telephone number
2. Upon ringing, the car alarm will indicate in 1-2 seconds with a short signal tone that it is ready to receive
instructions. From this moment on we have approximately 14-18 seconds to enter instructions, after which point
the unit will cut off the telephone line unless additional instructions are entered. Once you have entered an
instruction the 14-18 second timer will start again.
9.2 The 9 instructions after the beep:
1. By pressing button#1onthephone for 05-1 second the alarm is turned on in ON 1 mode, provided the alarm
was off previously. (THE SAMEAS REMOTE CONTROL ON 1) WE CAN ONLYTURN IT ON BUT WE CAN NOT
TURN IT OFF (OFF)
2. By pressing button #1 for at least 2 seconds we can activate the PANIC ALARM (THE SAME AS THE PANIC
ALARM ON THE remote control)