Owners manual

Two Pin Connector
BATTERY
Red (+)
Spring
Clip
Larger
Positive (+)
Post
Smaller
Negative (-)
Post
Black (-)
Spring
Clip
For uninstalled batteries we have supplied a lead set with spring clips.
Follow these steps for connection and operation (see illustration to right):
1. Make sure the Battery Extender is
NOT plugged in to an AC outlet
before connecting the clips to the battery.
2. (Model 9202 only.) Set the 12/16 volt switch to the voltage of the
battery you are connecting to.
3. Locate the positive (+) terminal post of the battery, it is usually larger
than the negative (-) terminal post. Connect the RED spring clip to
this battery terminal post. It’s a good idea to wiggle the clip on the
battery post to insure a good connection.
4. Connect the BLACK spring clip to the negative (-) battery terminal post.
5. Double check that the square two pin connector on the lead set is firmly
plugged into the square output connector of the Battery Extender.
6. Make sure the Battery Extender is safely located away from the
battery and in a non hazardous location.
7. Plug the AC cord in to a grounded outlet.
8. (Model 9202 only.) For 16V batteries, the red 16V light should be ON.
If the light is OFF, check that the 12/16V switch is in the correct position.
FOR USE WITH SPRING CLIPS
2
NOTE: The Battery Extender may switch back into full
charge mode (Amber light ON) as required by
your battery, this is normal.
BATTERY EXTENDER OPERATING INSTRUCTIONS
No Lights: Means one of the following:
• You reversed the connections by connecting the red spring clip to the
negative (-) battery post and the black spring clip to the positive (+)
battery post.
• You have a poor connection at the battery.
• There is no AC power.
Check all three!
Amber light (Charge): The Battery Extender is delivering up to a 1 Amp charge.
Green light (Maintain): The Battery Extender is safely maintaining your
battery at a full charge.Your battery is ready to go when you need it!
Amber Flashing Light = Defective Battery: The Battery Extender is
designed to detect either sulfated battery or dead cell. Make sure that the
battery post and clamp are clean. If the amber light continues to flash the
battery should be replaced.
Your Battery Extender is equipped with sophisticated circuitry that will
safely charge and maintain both 12 and 16 Volt batteries without
Ma intain
Charge
A
u
t
o
M
e
t
e
r
P
r
o
d
u
c
t
s
,
I
n
c
.
4
1
3
W
.
E
l
m
S
t
.,
S
y
c
a
m
o
r
e
,
I
L
6
0
1
7
8
Battery Extender
1
2
V
B
a
tte
ry
C
h
a
rg
e
r/M
a
in
ta
in
e
r
E
x
te
n
d
s B
a
tte
ry
L
ife
M
odel 9
20
1
S
E
R
IE
S
T
M
T
M
T
M
®
16 Volt
When Lit
Green Light
(Maintenance Mode)
Amber Light
(1 Amp Charge)
overcharging. Make sure you read and follow the "General Safety Rules
for Safe Operation" before proceeding with this operating instruction.
BATTERY EXTENDER INDICATOR LIGHTS
Red Light
(16 Volt Opperation)
Model 9202 only