Installation manual

30
GDO-9 Owner Installation Instructions
Door Status Indicators
Door Opener State OPEN LED
(Green)
CLOSE LED
(Red)
STATUS
LED
(Yellow)
Beeper
Open On
Close On
Opening Flashing
Closing Flashing
Door travel stopped Flashing Flashing
Door obstructed
when opening
Flashing
Door obstructed
when closing
Flashing Beeps as door moves
Opener overloaded Alternating fl ashes Alternating
fl ashes
Door in open
position with Auto-
Close mode selected
One second
fl ashes
Pet Mode Engaged On On
Mains power
interrupted
Rapid fl ashes
Service Due On 3 Beeps At The Start Of Each
Cycle
Button Functions
Buttons Function
OPERATE Opens/Stops/Closes the door
DOOR CODE Codes a transmitter button for operate, vocation,
auxiliary and pedestrian functions
LIGHT CODE Codes a transmitter button for light function
FORCE MARGIN SET & PLUS (+) Increases the obstruction force margin setting
FORCE MARGIN SET & MINUS (-) Decreases the obstruction force margin setting
FORCE MARGIN SET (then) SET Resets the factory default force margin settings
AUTO CLOSE TIME (then) PLUS (+) Increases the auto close delay time
AUTO CLOSE TIME (then) MINUS (-) Decreases the auto close delay time
AUTO CLOSE TIME (then) SET Resets the factory default auto close delay time
MINUS (-) for 6 secs. Clears the door limits set positions. Limits then
need to be reset
PLUS (+) for 6 secs. Enters pet (pedestrian) position mode
SET (then power on) & hold until all LED’s are off Deletes control parameters excluding transmitter
storage memory
DOOR CODE (then power on) & hold until all LED’s
are off
Deletes all transmitter storage memory
SET & DOOR CODE (the power on) and hold until all
LED’s are off
Deletes all control parameters and transmitter
storage memory.
SET Re-initialises the Opener to re-calculate force
margin