Installation manual

ManualsBrandsAutomatic ManualsGarage Door OpenerGDO-9v2 SecuraLift

Owner Installation Instructions GDO-9 25

PE Beam & Auto-Close

WARNING! Photo electric beams must be installed

if the closing force at the bottom edge of the door

exceeds 400N (40kg) force.

Step 19 - Fitting the PE Beams (optional)

Afﬁ x the PE Beams in a strategic location within the

doorway. We recommend 150mm above the ﬂ oor

level and as close as possible to the door opening,

inside the garage.

Connect the wires from the PE Beam’s wiring

harness to the terminal block (Fig. 39). The wiring

diagram is for Model PE-2 (Order Code 90214).

Make sure to align the beams correctly. Follow the

manual supplied with the PE Beams.

WARNING: When using Auto-Close Mode and PE

Beams, the doorway must be clear of all obstructions

and persons at all times. The location of the beams

and manner in which it is installed might not give

safety protection at all times. Check to make sure

that the height of the beam and type used give

maximum protection possible.

Step 20 - Setting Up Auto-Close Mode

IMPORTANT NOTICE: It is compulsory to have PE

Beams installed when using Auto-Close mode.

Auto-Close mode is a function that automatically closes

the door a preset time after the PE Beams recognise that

a vehicle has left the garage.

The Auto-Close timer only starts after the PE Beam’s

path is broken the Auto-Close timer has been set. If the

PE Beam’s path is not broken the door will remain open

until the path is broken. If the opener incurs a physical

obstruction (i.e. not from the PE Beams) while closing

the door, it will re-open and not Auto-Close until the PE

Beam’s path is broken again.

Step 20.1 - Setting Auto-Close Time

Hold down the AUTO CLOSE TIME button (Fig. 40).

While holding in the AUTO CLOSE TIME button,

press the PLUS (+) button, - each press will add

one second to the Auto-Close delay.

To decrease the delay time follow Step 20.1(a)

and press the MINUS (-) button - each press will

deduct one second from the Auto-Close delay.

Press the OPERATE button or transmitter to open

the door. When the door is fully opened the

OPEN LIMIT LED will ﬂ ash to indicate that Auto-

Close mode is operational.

Break the PE Beam’s path momentarily to

initialise Auto-Close. When the door reaches the

fully opened position, the door will pause for the

set Auto-Close time and then close.

Accessories

RED

GOLD

PWR

AUX OUT

OSC

GND

PE ( 0 V )

BLACK

YELLOW

RED

YELLOW

RED

Receiver

Transmitter

Model PE-2

ﬁ g