Instruction manual

11
Note: The tool and blade should be at a 45° angle to the
oor to allow the corner of the blade to plunge cut into the
ooring.
5. While holding the tool tightly, slowly
plunge the corner of the blade into the
ooring until it cuts through the ooring.
Once the plunge cut is complete, then
complete the cut to the corner of the
rectangle.
6. Turn the saw OFF, remove it from the
cut and proceed to cut in the opposite
direction to complete the cut for the rst
side of the rectangle.
7. Repeat steps #4, #5 & #6 to cut the
remaining three sides of the rectangle.
8. When all cuts are complete, use a at
blade screw driver to carefully pry the cut-
out from the oor.
Note: Do NOT use the saw blade to pry the cut-out from
the oor. You will break the blade. If the cut-out is not easy
to pry from the oor, check to make sure each line is cut
completely into the corner of the rectangle.
Using the sander attachment
1. Install the sanding pad on the multi tool as
outlined on page 10.
2. Install the sandpaper on the sanding pad.
3. Turn the switch ON.
This tool is designed for detail sanding on small surface
areas. Place the sandpaper surface of the sanding pad on
the workpiece to be sanded. Keep the tool moving to avoid
gouging the surface.
oor tile.
Note: Hold the tool tightly and do not put too much
forward pressure on the saw blade when cutting, as this will
cause the tool to vibrate excessively.
5. Continue to make several plunge cuts until
the bottom of the door jamb and casing
are completely cut off and the loose
pieces can be easily removed.
Follow the same basic procedure for installing carpet, using
a thicker spacer that is the same thickness of the carpet
being installed.
Cutting a hole in wood ooring to
install a heating vent
The oscillating tool can be
used to cut a hole in wood
ooring for installing a
heating vent.
1. Install the plunge
cutting saw blade
for wood in the
tool.
Note: The blade should be
centred on the tool housing
and NOT installed in the 90°
position.
2. Place the oor vent on the oor and use
a soft lead pencil to trace the required
rectangular hole (1) on the ooring.
3. Place the saw blade (2) near the oor
surface in the middle of one of the cutting
lines.
4. Turn the tool ON.