Installation manual

Owner Installation Instructions GDO-9v2 Enduro™
7
Gen 2
SmartSolar™ and Battery Backup Compatibility (optional)
The opener can be fitted with a SmartSolar™ or Battery Backup kit for operation in the
event of a power outage, or where mains power access is not available.
NOTE: If the door is the only entrance to the garage, and a battery backup kit is not
fitted, a keyed cable release should be fitted externally to the garage.
Pet/Pedestrian mode
The transmitter can be programmed to open the door to an adjustable partial
height so that the family pet can enter and exit the garage at any time. You may
also wish to open the door to a height suitable only for pedestrian access.
Auto-Close mode
The opener can be programmed to automatically close after an open cycle. The
Auto-Close time is adjustable. It is compulsory to install a Photo Electric (PE) Beam
if this mode is selected, otherwise the door may cause personal injury or damage
to property.
Safety Beam (optional)
The opener has an input to connect a Safety Beam for extra safety and use of the
Auto-Close mode. Easy Beam PE 3 kit or Wireless PE Beam kit can be used with this
opener.
Safety Beam Failure Emergency Close
When a safety beam prevents movement due to any reason other than a ‘real’ obstruction, the
user can secure their property by pressing and holding a button on the remote control or OSC
on the console.
Manual operation
The opener is equipped with a unique manual disengaging device. If the power to the opener is disrupted, the
door can be put into manual mode by pulling down on the string handle on an angle towards the door. This
allows for manual operation of the door. To re-engage the opener, pull the string handle away from the door.
Service Indicator
The opener has a built in counter with a default setting of 3000 cycles. When the counter expires the opener will
beep and flash to indicate a service is required.
GDO-9v2GEN2 User Manual v101.indd 7 15/11/2012 10:07:36 AM