Installation manual

Owner Installation Instructions GDO-9v2 Enduro™
29
Gen 2
Door Status Indicators
Door Opener State OPEN LED
(Green)
CLOSE LED (Red) STATUS LED
(Yellow)
Beeper
Open On
Close On
Opening Flashing
Closing Flashing
Door travel stopped Flashing Flashing
Door obstructed when opening Flashing
Door obstructed when closing Flashing Beeps as door moves
Opener overloaded Alternating flashes Alternating flashes
Door in open position with Auto-
Close mode selected
One second flashes
Pet Mode Engaged On On
Mains power interrupted Rapid flashes
Service Due On 3 Beeps At The Start
Of Each Cycle
Button Functions
Buttons Function
OPERATE Change speed mode, Opens/Stops/Closes the door,
pressing & holding will close the door in the event of safety
beam failure.
DOOR CODE Codes a transmitter button for operate, vocation, auxiliary and
pedestrian functions
LIGHT CODE Codes a transmitter button for light function
FORCE MARGIN SET & PLUS (+) Increases the obstruction force margin setting
FORCE MARGIN SET & MINUS (-) Decreases the obstruction force margin setting
FORCE MARGIN SET (then) SET Resets the factory default force margin settings
AUTO CLOSE TIME (then) PLUS (+) Increases the auto close delay time
AUTO CLOSE TIME (then) MINUS (-) Decreases the auto close delay time
AUTO CLOSE TIME (then) SET Resets the factory default auto close delay time
MINUS (-) for 6 secs. Clears the door limits set positions. Limits then need to be
reset
PLUS (+) for 6 secs. Enters pet (pedestrian) position mode
SET (then power on) & hold until all LED’s are off Deletes control parameters excluding transmitter storage
memory
DOOR CODE (then power on) & hold until all LED’s
are off
Deletes all transmitter storage memory
SET & DOOR CODE (the power on) and hold until all
LED’s are off
Deletes all control parameters and transmitter storage
memory.
SET Re-initialises the Opener to re-calculate force margin
GDO-9v2GEN2 User Manual v101.indd 29 15/11/2012 10:07:52 AM