Installation manual

Owner Installation Instructions GDO-9v2 Enduro™
27
Gen 2
49
fig
Final Setup
Step 23 - Setting of Courtesy Light Time
The preset courtesy light time is three minutes. This time
can only be changed by “PG3” programmer.
Step 24 - Setting the Pet Mode position
The default Pet Mode height can be changed as follows:
a. Drive and stop the door at the desired Pet Mode
open position by pressing OPERATE button on
the console or the transmitter button coded for
O/S/C operation.
b. Press and hold the OPEN button (Fig 49) for six
(6) seconds until the OPEN and CLOSE LED’s are
lit to record the new pet position.
When activated, Pet Mode drives the door to the preset
position from the close position. Pet Mode’s active status
is indicated by both the OPEN and CLOSE LIMIT LED’s
being illuminated. If a Pet Mode button is pressed while
the door is moving, the door will stop. If a Pet Mode
button is pressed when the door is in the Pet position,
then the door will close.
Step 25 - Installing the Wall Mounted
Transmitter (Optional)
a. Remove the faceplate from the transmitter.
b. Affix the baseplate in a convenient wall location
that is out of reach of children and convenient
to the customer (Fig 50). Make sure the door is
visible from this location.
c. Replace the faceplate.
d. To code the transmitter, see Steps 17.1 through
17.5 on page 21 and 22.
Step 26 - Reset all Factory Defaults
a. Turn power to opener off.
b. Press and hold the SET Button (Fig 51).
c. Turn power on while holding the SET button.
Continue to hold until all the LED’s are off.
d. This will not erase transmitter codes stored in
memory.
51
fig
50
fig
GDO-9v2GEN2 User Manual v101.indd 27 15/11/2012 10:07:52 AM