Installation manual
26
GDO-9v2 Enduro™ Owner Installation Instructions
Gen 2
45
Fig
46
Fig
WARNING: Do not connect batteries until Step
22.3
Step 22.1 - Mount the Charger Board
a. Unplug the drive unit from mains power.
b. Remove the screws, swing open the main cover and
remove the light diffuser. Then remove the transformer,
EMC board (if fitted) and mains power cable.
c. Mount the PCB support with two screws .Secure the
SOL charger board on to PCB support with 3 screws.
(Fig. 45).
d. Unplug the shunt & plug the solar charger Board’s
three wire harness (red/yellow/black) into the control
board’s “SBCO-2” connector on the control board
(Fig. 46).
e. Plug the solar shunt (supplied) onto the control
board’s “Jp1” connector marked “solar”(Fig. 46)
IMPORTANT WARNING: Do not connect battery
or solar panel polarity incorrectly - this will result in
serious damage to components.
Step 22.2 - Connect the Solar Panel
a. Mount the solar panel as outlined in the SmartSolar™
Installation Manual.
b. Feed the Solar Panel’s cable through black grommet
located on the top of the plastic drive unit cover.
c. Connect the red wire to the Charger Board’s
“SOLAR+” connector, and the black wire to the
“–SOLAR” connector (Fig. 47).
WARNING: During Step 22.3 the opener will
become active.
Step 22.3 - Mount & Connect the Battery
a. Mount the Battery Box close to the opener.
b. Feed the 2-core 18awg gauge cable (supplied)
through the Battery Box’s grommet.
c. Connect the red wire to the Battery Box’s “+” terminal,
and the black wire to the “–” terminal (Fig. 48).
d. Feed the other end of the battery cable through the
drive unit’s black grommet.
e. Connect the red wire to the Charger Board’s
“BAT+” connector, and the black wire to the “–
BAT” connector (Fig. 47).
f. Refit the light diffuser and main cover.
Step 22.4 - Re-setup and Test the Opener
a. Setup travel limits and code transmitters as per the
GDO-9v2 Enduro™
Gen 2
instruction manual.
b. Press either the OPERATE button or use a transmitter
to operate the opener.
B
l
a
c
k
(
F
r
o
m
B
a
t
t
e
r
y
)
R
e
d
(
F
r
o
m
B
a
t
t
e
r
y
)
R
e
d
Y
e
l
l
o
w
B
l
a
c
k
B
l
a
c
k
(
F
r
o
m
S
o
l
a
r
P
a
n
e
l
)
R
e
d
(
F
r
o
m
So
l
a
r
P
a
n
e
l
)
47
Fig
R
e
d
W
i
r
e
B
l
ack
Wi
r
e
48
Fig
SmartSolar™ Installation
GDO-9v2GEN2 User Manual v101.indd 26 15/11/2012 10:07:51 AM