Installation manual

Owner Installation Instructions GDO-9v2 Enduro™

Gen 2

Battery Backup Installation

Step 21.1 - Connect the Battery Back Up Kit

a. Disconnect power to the opener.

b. Remove screws and swing open the cover (Fig 44).

c. Mount the PCB support with two screws item # 13.

Secure the SBC0-2 Charger Board onto the PCB

support with three (3) screws item #14.

d. Feed the 2-wire battery harness item # 10 through

the grommet on the base plate and connect to

SBCO-2 battery charger board.

e. Feed charger harness from SBCO-2 battery charger

board to the control board and plug onto the 5 pin

connector marked “SBCO-2” on the control board.

f. Mount Battery Backup and secure with item 11 and

12.

WARNING: After Step 21.1(g) the opener may

become active (even when power is off). This is a

result of a residual charge in the batteries.

g. Connect battery harnesses item 5 and 10 together

(Fig 44).

h. Reconnect power.

fig

Step 21.2 - Testing Battery Back Up

a. Press either the OPERATE button or transmitter

to test the opener.

b. Whilst door is in motion, disconnect mains

power the door should continue to operate as

normal.

NOTE: Wait for the door to complete its travel.

c. Press the OPERATE button or transmitter to

activate the door.

d. Whilst door is in motion re-connect power. The

door should complete the cycle as normal.

Step 21.3 - Troubleshooting

If door stops or moves very slowly under battery

power, the batteries may be weak or have no

charge. Connect mains power and allow the

batteries to charge. This may take 24 - 48 hours to

reach maximum charge capacity.

Battery Backup Installation

GDO-9v2GEN2 User Manual v101.indd 25 15/11/2012 10:07:49 AM