Installation manual

Owner Installation Instructions GDO-9v2 Enduro™
23
Gen 2
RED
BLACK
RED
BLACK
RED
BLACK
BLACK
39
fig
40
fig
41
fig
Wired Safety Beams Installation
Step 19 - Safety Beams (optional)
Safety Beams extend across the garage door opening.
The Safety Beam is designed to detect an obstruction
while the door is closing and to send a signal to the
garage door opener to reverse or stop the door
movement. One or two sets of Safety Beams can be
connected to GDO-9v2 Enduro™
Gen 2
opener.
Step 19.1 - Fitting the Safety Beam
a. Attach the mounting bracket (4) to the adjustment
bracket (3) with the pan head screw (6) (supplied).
(Fig. 39)
b. Attach the bracket (2) to the Safety Beam
transmitter with four taptite screws (m3x5) and
attach the other side to the adjustment bracket (3)
with the pan head screw (6) . (Fig. 40)
c. Repeat steps a and b to assemble the Safety Beam
receiver.
d. Mount the receiver to one side of the door and
transmitter on the other side in line with receiver.
The mounting surface should be rigid. ATA
recommends the transmitter and receiver are
placed in line of sight, with the beam 100mm
above ground level (as per AS60335). They should
also be placed as close as possible to the door
opening. Connect as per the wiring diagram (Fig.
41).
Step 19.2 - Alignment
a. Power up the opener with the Safety Beam
connected. The green LED on the transmitter
should turn ON to indicate power is present.
b. If the receiver is connected to power and the
red LED is flashing while the green LED on the
transmitter is on, the transmitter and receiver are
not aligned.
c. Make horizontal and/or vertical adjustment on the
transmitter and/or receiver until the red LED on the
receiver turns on, indicating alignment.
NOTE: The sensors need to be 100mm above
the floor level, however, the exact position
must be chosen in such a manner that it suits
the application, the environmental conditions
and provides maximum safety protection.
WARNING: Safety Beam must be installed if
the closing force as measured at the bottom
edge of the door exceeds 400N (40kg).
NOTE: Three wire Safety Beam is not compatible with
GDO-9v2 Enduro™
Gen 2
opener.
1
2
3
4
6
6
GDO-9v2 Enduro™
Gen 2
is compatible with wireless safety beams. Please
refer to instructions provided with wireless safety beams for installation
details.
GDO-9v2GEN2 User Manual v101.indd 23 15/11/2012 10:07:47 AM