Installation manual

Owner Installation Instructions GDO-9v2 Enduro™
19
Gen 2
27
fig
28
fig
Safety Obstruction Forces
Safety Obstruction Force Test
WARNING! Take care when testing or adjusting
the Safety Obstruction Force. Excessive force
may cause SERIOUS PERSONAL INJURY and/or
PROPERTY DAMAGE.
WARNING! Photo electric beams must be installed
if the closing force at the bottom edge of the door
exceeds 400N (40kg) force.
Step 15.1 - Testing Close Cycle
a. Press the OPERATE button to open the door (Fig.
27).
b. Place a piece of timber approximately 40mm high
on the floor directly under the door (Fig. 34).
c. Press the OPERATE button to close door. The door
should strike the object and start to re-open.
Step 15.2 - Testing Open Cycle
a. Press the OPERATE button to close the door (Fig.
28).
b. Press again to open the door. When the door
reaches the half open point, grab the bottom rail of
the door firmly and the door should stop.
c. If the door does not reverse readily when closing,
or stop when opening, the force may be excessive
and need adjusting, refer below.
DANGER! If the door fails these tests, put the
opener into manual mode, only operate the door
by hand and call for service.
NOTE: Once the travel limits are set and safety
obstruction force tested check the chain or belt tension.
As per the sticker on the C-rail the chain or belt should
sag slightly, so there is a 5mm gap between the bottom
of the C-rail and the chain or belt.
The tension can be varied by using a spanner to adjust
the bolt at the door end of the C-rail.
Be sure not to over-tension the chain or belt as this can
cause damage to the C-rail or opener.
40mm block of wood
GDO-9v2GEN2 User Manual v101.indd 19 15/11/2012 10:07:44 AM