Installation manual

GDO-9v2 Enduro™ Owner Installation Instructions

Gen 2

fig

Setting Speed and Limits

Step 13 - Setting Speed Mode

The default speed of the opener has been set to suit the

majority of applications. However, there are three speed

modes available if required:-

1. Slow - to suit one piece door without tracks

2. Medium ( default ) - suits majority of applications

3. Fast - to suit some sectional applications

The speed settings can only be changed before setting

the travel limits. If the opener speed needs to be changed

please complete the steps below. If medium (default)

mode is appropriate skip straight to step 13.1 setting travel

limits. Pressing the operate button will cycle through all

three speed modes. To change the speed setting:-

a. Engage the C-Rail’s trolley (attached to the door via

the arms) with the chain index by moving the door.

b. If the trolley does not “click” firmly onto the chain

index, ensure that the manual release cord is not in

the disengaged position by pulling it backwards.

c. Turn on the power to the opener. The CLOSE LIMIT

LED will be flashing.

d. Remove the button cover with a blade screwdriver

(Fig. 21).

e. Press operate button once, twice or three times to

select slow, medium or fast speed mode.

Door Opener

Speed Mode

OPEN

LED

(Green)

LED

(Red)

Beeper

Medium ( Default ) On On 2 beeps

Fast On Off 3 beeps

Slow Off On 1 beep

GDO-9v2GEN2 User Manual v101.indd 16 15/11/2012 10:07:43 AM