Installation manual

Owner Installation Instructions GDO-9v2 Enduro™

Gen 2

C-Rail Attachment

fig

Locate shaft into sprocket

Shaft

Hex flange screw taptite ‘S’ M4 x 10

Track bracket (x2)

Single piece

C-Rails are pre-tensioned during manufacturing for

transport. Some extra tension may be required after

installation.

If the C-Rail needs to be shortened or lenghtened (using

the extension kit) ensure these modifications are made

to the drive unit end.

Step 1 - Secure C-Rail to Drive Unit

a. Locate and insert the shaft of drive unit into the C-

Rail’s sprocket (Fig. 04).

b. Fix the two track brackets with four screws supplied

in accessory pack (Fig. 05).

GDO-9v2GEN2 User Manual v101.indd 11 15/11/2012 10:07:39 AM