Instruction Manual

Dominator EasyRoller Instruction Manual

6.10 Coding Transmitters

Fig.6.10.1

6.10.1 Setting Premium Remote Control and Wall Control Codes

The opener can only operated from remote control transmitters that

have been programmed into its memory. Up to 64 codes can be stored

in the memory.

a. Press and hold the DOOR CODE button (Fig 6.10.1).

b. Press Button 1 on the transmitter for two seconds. Release and

pause for two seconds. Press the Button 1 again for two seconds.

c. Release the DOOR CODE button. The transmitter button is now

coded, press to test.

Function DOOR CODE

Button presses

OPENER

Vacation Mode twice (2) Opener will beep 2 times on second press

Enable AUX Output three (3) Opener will beep 3 times on third press

PET (pedestrian) Mode four (4) Opener will beep 4 times on the fourth press

Courtesy Light Press & hold LIGHT CODE and code as per 6.6.1.

Press DOOR CODE

button once

Select one of the four

buttons that you wish

to use to control the

door

6.10.2 To Erase Programmed Codes

If the DOOR CODE button is pressed and held on for 6 seconds, the LED will

blink rapidly for one second to indicate that all programmed codes have been

erased (Fig 6.10.2).

Fig.6.10.2

WARNING! The manufacturer is not responsible for any radio

or TV interference caused by unauthorized modifications to

this equipment. Such modifications could void the user’s

authority to operate the equipment.