Instruction Manual

Diamond PD Power Drive : Instruction Manual
Dominator EasyRoller Instruction Manual
13
© Copyright 2018
6.5. Mounting the Opener
Tighten
U-bolts
6.5.1 Raising the Door:
a. When in position, remove the U-bolt (or bolts) and saddle from the door bracket.
b. Lift the door up and away from the wall until clear of the door bracket, before
lowering the door to rest on the door stand or prop. (Fig 6.5.1)
NOTE: If there is limited ceiling space to lift the door, the door bracket may have to be
removed. If this is required, when refitting the door bracket , use the reference marks on the
wall for correct position and ensure that it is secure to the wall and will support the door.
Lift door
up, away
from wall
and down
onto prop
WARNING! For tight sideroom installations the door may have to
be taken down.
6.5.2 Mounting the Opener:
a. Remove the opener from the box.
b. Check the drive gear rotates freely, by pulling
the string handle down (there will be a click) to
disengage opener. Then move the forks from side
to side by hand.
c. Slide the opener over the door axle and into the
drum of the door as shown in Fig 6.5.2.
d. Push the opener in as far as possible (without
interfering with the curtain) SO ONE OF THE
DOOR DRUM’S WHEEL SPOKES IS BETWEEN THE
OPENER’S DRIVE FORKS.
e. Raise the door off the door stand or suitable prop.
f. Lift up and over the door bracket and use your
reference marks on the door bracket to position the
door.
g. Refit the U-bolt and nuts and tighten (Fig 6.5.3).
h. Remove the safety rope and door stand or prop.
i. Connect the power cort to a suitable powerpoint,
but DO NOT SWITCH ON.
j. Secure the power cord away from any moving
object (e.g the door) with the cable clip supplied.
k. With the opener still disengaged, pull the door up
and down to make sure it runs freely.
NOTE: After Installation, ensure that parts do not extend
over public footpaths or roads.
Fig. 6.5.2
Fig. 6.5.1
Pull string
down to
disengage
opener
Slide opener
over door
axle
Fig. 6.5.3