Instruction Manual

10
ATS-3AM & ATS-2AM Dominator Tempo & Syncro Instruction Manual
6.2 Mounting Operator for a Track Type Door
Fig.6.2.3
Fig.6.2.2
Fig.6.2.1
WARNING! To reduce the risk of injury to persons -
Use this operator only with a sectional door.
6.1 C-Rail Assembly
Fig.6.1.2
Fig. 6.1.1
6.2.1 Determine Bracket Position
a. Determine the centre of the door and mark this point with a line on the wall above.
b. Raise the door and find the highest point of travel of the first (top) door panel.
c. Using step ladder and a level, transfer this height to the wall above the door and
mark a line 2.36”(60mm) above it, across the centre line (Fig.6.2.1).
6.2.2 Mounting the Wall Bracket
d. Draw two lines extending 0.846” (21.5mm) from each side of the centre point
(Fig.6.2.2).
e. Centre the wall bracket
6
over the intersection of these two lines. Mark centres
for at least two holes and ensure it is into a solid mounting point.
f. Drill holes in the wall with an appropriate bit.
g. Secure to the wall using:
(i) IF CONCRETE OR BRICK:
8mm (5/6”) loxins/dynabolts.
(ii) IF TIMBER:
wood screw #20 or similar (
minimum 1.97” 50mm long) (Fig.6.2.2).
WARNING!: Make sure concrete, brick wall or timber lintels are solid and sound so as
to form a secure mounting platform.
6.2.3 Attach the C-Rail to the Wall Bracket
a. Leave the drive unit in its packing box on the floor for protection and lift the other
end of the C-Rail.
b. Attach the C-Rail assembly
17
to the wall bracket
6
with the
3.54” (90mm) long pin
11
and secure with the supplied pin snap
9
(Fig.6.2.3).
6.1.1 Installing the C-Rail
a. Remove the Opener from the box.
b. Locate and insert the shaft of drive unit
1
into the C-Rail’s sprocket as shown in Fig 6.1.
c. Fix the two track brackets
16
with four (4) M4 x 8 screws
14
supplied in accessory pack (Fig 6.1.2).
d. Place drive unit back in packing box for protection.
Locate shaft into
the sprocket
17
1
16
14
60mm
Level
17
11
9
6
6
ELECTROCUTION! This operator is
not equipped for permanent wiring.
Contact a qualified electrician to
install a suitable receptacle if one is
not available.