User's Manual

Fig.29

Fig.30

Fig.31

Coding Transmitters

Step 13.5 - Setting the Transmitter to Operate Pet

(Pedestrian) Mode (Fig.29)

The operator can be programmed into a “Pet Mode” where

the door opens partially to allow pets to enter/exit the

garage:

Press the a. DOOR CODE button ve times, the DOOR

CODE LED will illuminate and the courtesy light will ash

quickly (twice per second) to indicate learning mode for

Pet Mode is active.

Choose a transmitter button not already coded into the b.

receiver. Press this button and the DOOR CODE LED

will begin to ash.

Press the same transmitter button again. The DOOR c.

CODE LED will illuminate for one second and then go

out, and the courtesy light will also switch off. This

indicates the code has been stored. This indicates the

code has been stored.

The opening height of the door for pet position can only d.

be changed with a universal programmer.

Step 13.6 - To Erase Programmed Codes (Fig.30)

If the DOOR CODE button is pressed and held for 6 seconds

the DOOR CODE LED will blink rapidly for one second to

indicate that all programmed codes have been erased.

Step 13.7 - Installation of the Wall Mounted

Transmitter (Fig.31)

Mount the transmitter in a convenient location, yet out a.

of reach of children and at least 5 feet (1.53m) off the

ground, and

Away from all moving parts of the door.b.

Make sure the door is visible from this location.c.

To set the transmitter codes, refer to d. Step 13.1.

NOTE: The manufacturer is not responsible

for any radio or TV interference caused

by unauthorized modications to this

equipment. Such modications could

void the user’s authority to operate the

equipment.

PA800V1 Instruction Manual (Instructions d’installation)20